Print this page

The main components of the Dexon Clean Air Handling System are the Control Centre and the Air-Handler.

The Control Centre interfaces with the various heating and cooling sources, pumps, temperature sensors and monitors to efficiently maintain the pre-set parameters of the system. Depending on the options chosen the system can be fully automatic or can allow for some owner intervention.

The Air Handler houses the controls, blower and the coils for heating and cooling and the various air filtration options.

• It is modular in design so that it can easily fit through regular doors and consists of a minimum of 4 modules.
  • Module 1 which can be used for either the Return Air or Outside Air Intake depending on installation requires.
  • Module 2 can also be used for either the Return Air or Outside Air Intake
  • Module 3 houses the blower and controls
  • Module 4 houses the coil and provisions for optional filtration.
• Is dual skinned and fully insulated to prevent thermal bridging with no foil back insulation in the air stream.
• All modules are powder-coated wrinkle black inside and out to prevent off gassing with attractive Stainless Steel Hoods.
• Gasket between modules, as well as tight fitting filters, ensures that the maximum amount of air passes through air filters rather than around them.
• Controlled Return Air and Outside Air Intake dampers can provide up to 100% outside air intake that would also pass through the various filter options.
• Both Return air and Outside Air Intake modules are equipped with special prefilters, made of patented blend of activated carbons on a GM6.0, Merv 7 particulate media.

Air Handler is available in vertical or horizontally configuration